129
Trim (volume
trim)
Volume Trim is a pre-fader control which allows the fine
tuning of a single track’s volume.
For example, let’s say you have four tracks, three tracks
have their volume fader set to 0 dB while the fourth track’s
fader is set to +10 dB. You want to group the faders and do
a slow fade out, but the slightly higher level of the fourth
track causes its volume to be higher in relation to the other
tracks towards the end of the fade out. To balance the fader
levels, reduce the fader level for the fourth track to 0 dB and
raise the Volume Trim value for that track to +10 dB. The
resulting volume levels for the project are the same, but now
you can group the faders and perform a fade out with no
track standing out disproportionately at the end of the fade
out.
Bus Enable Allows the track to be sent to the bus.
Bus Send Level Each track has a Bus Send Level for each Bus in the
project. The default number of Buses for a new project is 2.
Bus Send Pan Each track has a Bus Send Pan for each Bus in the project.
The Bus Send Pan adjusts the send pan setting.
Bus Pre/Post Each track has a Bus Send Pre/Post for each Bus in the
project. Pre (pre-fader) means that the signal goes to the
bus prior to the track’s volume fader.
Mono/Stereo A switch that determines whether a track’s signal enters an
effect or chain of effects as mono or stereo, regardless of
the nature of the track.
Phase In/Out A switch that inverts the phase of the track.
Effects bin The patch point for a track’s DirectX plug-ins or DXi soft
synths.
Meters The recording and playback levels are displayed in the
Playback and Record meters.
To Next Page
Loading...