316
SONAR adds a controller at the indicated point.
To Draw a Linear Series of Controllers
1. Choose the data type, controller or xRPN number, and channel (if applicable)
from the lists in the toolbar.
2. Select the tool.
3. Drag a line in the Controllers pane from the starting time and value to the
ending time and value.
SONAR adds a series of controllers and erases any existing controller values in the
same time interval.
To Draw a Series of Controller Value Changes
1. Choose the data type, controller or xRPN number, and channel (if applicable)
from the lists in the toolbar.
2. Select the Draw tool .
3. Drag the cursor across the Controllers pane, adjusting the value as you move
left to right.
SONAR adds a series of controllers and erases any existing controller values in the
same time interval.
To Insert a Series of Controllers
1. Choose Insert-Series of Controllers to display the Insert Series of
Controllers dialog box.
2. Choose the controller type from the Insert list.
3. Choose the controller number or type from the Number list.
4. Use the spinners or enter the desired MIDI channel.
5. Enter a starting and ending value in the Begin and End boxes.
6. Enter a starting and ending time in the From and Thru boxes.
7. Click OK when you are done.
SONAR inserts a series of controller events with values that change smoothly over
time from the starting to the ending value indicated in the dialog box. This
command never inserts more than one event on the same clock tick. If any
Tip:
When using the Draw tool , you can press and hold the Shift key
to draw a straight line.
To Next Page
Loading...