453
To Create a Custom Group
1. Right-click on any control in the group and choose Group Properties to
display the Group Properties dialog box.
2. Choose Custom as the group type. The starting and ending values for each
control are displayed.
3. To change the starting or ending value for a control, click on the control in the
list and enter new values in the Start and End box.
4. To swap the starting and ending value, click the Swap button.
5. Click Close when you are done.
SONAR uses the type to determine the range of motion for the group’s controls.
To Adjust the Start Value of a Control
1. Set the control to the desired starting value.
2. Right-click on the control.
3. Choose Set Start = Current.
SONAR sets the start value of the control.
The Set Start = Current and Set End = Current commands set the range of
motion that a grouped control moves through as the other members of the group
move through their starting and ending values. You don’t have to designate a
group as a custom group to create a custom group—just group some controls and
set their starting and ending values.
To Adjust the End Value of a Control
1. Set the control to the desired ending value.
2. Right click on the control.
3. Choose Set End = Current.
SONAR sets the end value of the control.
The Set Start = Current and Set End = Current commands set the range of
motion that a grouped control moves through as the other members of the group
move through their starting and ending values. You don’t have to designate a
group as a custom group to create a custom group—just group some controls and
set their starting and ending values.
To Next Page
Loading...