Turning OFF the Printer
To stop the printer properly, use the following procedure for turning the printer OFF.
1
Check that the printer is not performing the following operations.
Printing
While the printer is running a self-diagnostic test immediately after turning the power ON
While the
(Job) indicator is on or blinking
When any of the following messages appears
<Starting up...>
<Initializing NVRAM>
2
Press [ ] ( : Reset).
3
Select [Shut Down] using [ ] and [ ], and then press [OK].
IMPORTANT
If "Could not execute." is displayed
There is a Secure Print job in the SD card.
If shutdown is running, after deleting the job using a soft reset, run the shutdown operation again.
If shutdown is not running, press [
] ( : Online).
NOTE
When you are using WSD printing
The shutdown notifies the computer that the printer is turned OFF.
4
Select [Yes] using [ ], and then press [OK].
ĺ After the message appears, the printer turns OFF automatically.
㻝㻣㻟㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
