0978-0AC
NOTE
Table description
Bold values in the table indicate the default settings.
This item is displayed only when all the following conditions are met.
[Network] in [Interface Selection] is set to [On].
After changing the settings for this item, cycle the power of the printer or perform a hard reset to make the settings
effective.
The setting items or setting values with "*" may not be displayed depending on the availability of the optional
accessories and other settings.
Setting Item Setting Value Setting
[TCP/IP Settings]
Specifies the TCP/IP setting for the print server equipped with this
printer.
[IPv4 Settings]
[IPv4]: [Off], [On] When using IPv4, set it to [On].
[IP Mode]: [Auto],
[Manual]
Select the method for setting the IP address.
When setting the IP address using any one of DHCP, BOOTP,
or RARP, select [Auto].
When specifying the IP address to the printer directly, select
[Manual].
[Protocol]
*
:
[Use DHCP]:
[Off], [On]
[Use BOOTP]:
[Off], [On]
[Use RARP]:
[Off], [On]
If you set [IP Mode] to [Auto], select which protocol you want to use.
Set each of [Use DHCP], [Use BOOTP], and [Use RARP] to [On]
(use) or [Off] (do not use).
[IP Address Settings]:
[IP Address]:
0.0.0.0
[Subnet Mask]:
0.0.0.0
[Gateway
Address]: 0.0.0.0
Specify [IP Address], [Subnet Mask], and [Gateway Address].
For the method for entering the addresses, see "Method for entering
addresses" below the table.
[DNS]:
[Primary
Address]: 0.0.0.0
[Secondary
Address]: 0.0.0.0
Specify [Primary Address] and [Secondary Address] for DNS.
For the method for entering the addresses, see "Method for
entering addresses" below the table.
Specify the settings for [Host Name], [Domain Name], and [DNS
Dynamic Update] from the Remote UI.
"Configuring the Protocol Settings"
[DHCP Option]:
[Acquire Host
Name]: [Off],
[On]
[DNS Dynamic
Update]: [Off],
[On]
Set DHCP options when [IP Mode] is set to [Manual] and [Use
DHCP] is set to [On].
When obtaining the host name using DHCP, set [Acquire Host
Name] to [On].
When updating the host name using DHCP, set [DNS Dynamic
Update] to [On].
[IPv6 Settings] [IPv6]: [Off], [On]
If you want to use IP v. 6, specify [On].
*
Specify the setting for IP v. 6 from the Remote UI.
"Setting IP v. 6"
[Setup] Menu ([Network] Options)
㻡㻣㻜㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
