[WINS Resolution] [Off], [On]
If you want to use WINS Resolution, specify [On].
*
Specify the following settings from the Remote UI.
[WINS Server Address]
[Scope ID]
[SMB Server Name]
[SMB Workgroup Name]
"Configuring the Protocol Settings"
[ARP/PING] [Off], [On]
When it is set to [On], you can change the IP address settings from
the client using ARP/PING commands.
[FTP]
[FTP Print]: [Off],
[On]
[FTP Settings]: [Off],
[On]
When it is set to [On], you can access the printer's FTP server
using the FTP client and print the files.
If you want to perform the settings using FTP Client, set [FTP
Settings] to [On].
*
Specify the settings for [FTP Print User Name] and [Password]
from the Remote UI.
"Configuring the Protocol Settings"
[LPD Print] [Off], [On]
If you want to use LPD Print, specify [On].
*
Specify the setting for [Print LPD Banner Page] from the
Remote UI.
"Configuring the Protocol Settings"
[RAW Print] [Off], [On]
If you want to use RAW Print, specify [On].
*
Specify the setting for [Use Bidirectional Communication] from
the Remote UI.
"Configuring the Protocol Settings"
[IPP Print] [Off], [On]
If you want to use IPP Print, specify [On].
*
Specify the settings for [IPP Authentication], [User Name], and
[Password] from the Remote UI.
"Configuring the Protocol Settings"
[WSD]
[WSD Print]: [Off],
[On]
[WSD Browsing]
*
:
[Off], [On]
[Multicast Discovery]:
[Off], [On]
If you want to use WSD Print, set [WSD Print] to [On], and then
specify the following settings.
If you want to obtain printer information using WSD, set [WSD
Browsing] to [On]. If you set [WSD Print] to [On], [WSD
Browsing] is not displayed. ([WSD Browsing] is fixed at [On].)
If you want to set the printer to respond to requests from
multicast discovery, set [Multicast Discovery] to [On].
[HTTP] [Off], [On]
When it is set to [On], you will be able to access the printer
using HTTP.
When this is set to [Off], the message appears, disallowing you
to use the Remote UI or perform IPP printing.
[Proxy]: [Off], [On] If you want to use the proxy function, specify [On].
[Server Address]
*
: -
Enter the proxy server address to be used for the proxy function.
[Port Number]
*
: 1 to
80 to 65535
Enter the port number of the proxy server to be used for the proxy
function. You can specify between [1] and [65535].
[Same Domain]
*
: [Use
Proxy], [Do Not Use
Proxy]
If you want to use the proxy function also for the same domain,
specify [Use Proxy].
㻡㻣㻝㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
