UIDL Error
the UIDL command.
EM E-Mail access
error.
The printer could not connect to the
POP3 server because an error had
occurred in its hard disk.
Clear the hard disk error on the POP3
server.
The error codes that are displayed in the e-mail receive log list
*
If multiple errors have occurred, only the error of the highest priority is displayed (high: 407 > low: 499).
Error Code Cause Remedy
407
The connection to the POP server was
disconnected.
Consult your network administrator.
If errors occur many times on the same e-mail
data, check if the e-mail data is normal.
Could not receive data of 1 Kbyte
(1024 byte) for 10 minutes while
receiving e-mails.
408
The response <ERR> was returned
from the POP server.
Consult your network administrator.
412
Could not receive data of 1 Kbyte
(1024 byte) for 10 minutes while
receiving e-mails.
Consult your network administrator.
If errors occur many times on the same e-mail
data, check if the e-mail data is normal.
420
The size of the e-mail data exceeded
1.5 GB.
Reduce the size of the e-mail data to 1.5 GB or
less.
421
The size of the e-mail text exceeded
25 MB.
Reduce the amount of the e-mail text.
422
The size of the attached files
exceeded 100 MB.
Reduce the size of the attached files to 100 MB or
less.
423
An attached file in an unsupported
format was sent.
Change the format of the attached file into TIFF or
JPEG.
424
The number of the attached files
exceeded 3.
Reduce the number of the attached files to 3 or less.
430
An e-mail in which [From] is blank was
sent.
Enter a name in [From].
431
Received a divided mail.
Apply the following remedies to send the e-mail so
that it is not divided.
Reducing the size of the e-mail to be sent
(Reducing it to the size which cannot be
divided).
Specifying the application settings so that the
e-mail is sent without being divided.
An e-mail which included unsupported
encoding or character encoding was
sent.
Change the encoding or character encoding into that
supported by this printer.
"Receiving E-mail Data on the Mail Server and
Printing (E-mail Print)"
Received a mail of an unsupported
type (message type).
Change the content type into any one of the
following types that are supported by this printer.
text/plain
image/jpeg
image/tiff
image/tiff-fx
application/octet-stream
Change the content type of the multipart mail into
any one of the following types that are supported by
this printer.
㻟㻞㻜㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
