3
Configure the Ethernet driver.
This printer can detect the communication method and Ethernet type automatically. Normally, set [Auto Detect] to [On].
If you want to fix the communication method and Ethernet type, set [Auto Detect] to [Off].
If you are using a hub, match the settings for the hub and the printer. For the settings of the hub you are using, consult
your network administrator.
(Example)
Hub settings
Communication mode: Full duplex
Ethernet type: 10 Base-T
Printer settings
[Auto Detect]: [Off]
[Communication Mode]: [Full Duplex]
[Ethernet Type]: [10 Base-T]
When detecting the Ethernet driver automatically (Default)
(1) Select [Auto Detect] using [
] and [ ], and then press [OK].
(2) Select [On] using [
] and [ ], and then press [OK].
When detecting the Ethernet driver manually
(1) Select [Auto Detect] using [
] and [ ], and then press [OK].
(2) Select [Off] using [
] and [ ], and then press [OK].
(3) Select [Communication Mode] using [
] and [ ], and then press [OK].
(4) Select an Ethernet communication method appropriate for your network environment using [
] and [ ], and then
press [OK].
[Half Duplex]: Receives and transmits data alternately, not simultaneously.
[Full Duplex]: Receives and transmits data simultaneously.
(5) Select [Ethernet Type] using [
] and [ ], and then press [OK].
(6) Select an Ethernet type appropriate for your network environment using [
] and [ ], and then press [OK].
4
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE
For details on a hard reset
See "Canceling All the Jobs (Hard Reset)."
㻟㻡㻟㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
