Canon LBP6780x - Page 417

0978-08A
There are the following three methods for setting the IP address.
Setting the IP Address Using the Printer's Control Panel
Set the IP address using the control panel while checking the display on the printer.
Setting the IP Address Using the ARP/PING Commands
Set the IP address using the ARP/PING command in Command Prompt.
Setting the IP Address Using NetSpot Device Installer
Set the IP address using NetSpot Device Installer in the supplied CD-ROM.
IMPORTANT
When setting the IP Address using the ARP/PING command or NetSpot Device Installer
The MAC address of the printer is required. For details on the procedure for checking the MAC address, see "Checking
the MAC Address."
Before setting the IP address
Make sure that the printer is connected to the network and the printer is ON.
NOTE
If you changed the IP address after installing the printer driver
Specify the port to be used again in the printer driver.
"Configuring a Computer that Performs Printing"
Setting the IP Address (IP v. 4)
㻠㻝㻣㻌㻛㻌㻥㻣㻜