Canon LBP6780x - Page 487

\NetSpot_Device_Installer\usa
Settings Using NetWare Administrator (When Using the Printer in NDS Queue Server Mode/NDS
Remote Printer Mode)
1
Log in to NetWare as "Admin" (or a user who has the equivalent permissions), and then run NetWare
Administrator.
1. Select [Print Services Quick Setup] from the [Tools] menu.
2. In [Print Server name], enter an arbitrary name. To use an existing print server, click the button on the right of [Print
Server name], and then select the print server from the list.
3. In [Name] for the printer, enter an arbitrary name.
4. When using the printer in Queue Server Mode, select [Other/Unknown] in [Type].
5. When using the printer in Remote Printer Mode, select [Parallel] in [Type], and then click [Communication]. Set [Port]
to [LPT1] and [Connection type] to [Manual load].
6. In [Name] for the print queue, enter an arbitrary name.
7. In [Volume], enter the volume object (the object that indicates the physical volume on the network) that creates the
queue. You can select the volume object from a list by clicking the button on the right.
8. Specify the other settings, and then click [OK].
NOTE
About entering the print server name
Because the print server name is required for the protocol settings for the printer, note it down.
About Quick Setup
If you perform Quick Setup, the printer is allocated to the printer number "0."
When using the printer in Queue Server Mode, do not change the printer number from "0."
2
When using the printer in Remote Printer Mode, start the print server.
When using the NetWare file server as the print server, enter "LOAD PSERVER.NLM" in the file server, and then press the
[ENTER] key on your keyboard.
ĺ The settings for NetWare print service are now completed.
NOTE
About Queue Server Mode
When using the printer in Queue Server Mode, you do not need to specify these settings.
3
Next, configure the NetWare protocol settings for the printer.
For details on the procedure for configuring the NetWare protocol, see "Configuring the Protocol Settings."
Settings Using PCONSOLE (When Using the Printer in Bindery Queue Server Mode/Bindery
Remote Printer Mode)
㻠㻤㻣㻌㻛㻌㻥㻣㻜