[Set/Change PIN] If nothing is entered for [PIN] with this check box selected, the state is such that
no password is specified.
[PIN] Enter the password using a number with up to seven digits.
[Confirm] For confirmation, enter the same password that you entered for [PIN].
[Clear Count]
(Not displayed depending on the settings.)
Clear [Printed Pages] ([Total Print]) for this Department ID.
[Total Print] Displays the number of printed surfaces.
(3) [Settings...]
(Displayed only if you have logged on in Administrator Mode.)
The [Department ID Management Settings] page allows you to enable/disable the department ID management
function and specify whether to print jobs with unknown IDs.
Set the following items and then click [OK].
[Enable Department
ID Management]
If the check box for this option is selected, you need to enter a department ID and
password when printing. You also need to enter a department ID and password
when you perform direct printing or manipulate boxes from the Remote UI. Jobs
which failed to be authenticated are deleted.
[Accept Print Jobs
With Unknown IDs]
If the check box for this option is selected, you can print jobs with unknown IDs. If
the check box for this option is not selected, you cannot perform printing even
from the Remote UI that you have logged on in system manager mode. Jobs with
unknown IDs indicate the following kinds of jobs.
Jobs printed by a printer driver which does not support the department ID
management
Jobs directly printed using a method other than the Remote UI
(4) [Printed Pages]
Displays the number of printed surfaces.
(5) Delete the Selected Department
(Displayed only if you have logged on in Administrator Mode.)
If you click [Delete] to the right of the Dept. ID to be deleted, the selected Dept. ID is deleted.
(6) [Clear All Counts]
(Not displayed depending on the settings.)
Clears [Printed Pages] of all the departments.
㻢㻞㻤㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
