Set below paper.
<Cause 1> The paper of the size specified in the application is not loaded in the paper drawer or multi-
purpose tray, or the paper source for the different paper size is selected.
Solution 1
Load the paper of the size selected in the application (or the one specified by scaling factors).
"Paper Loading and Output"
Solution 2
Press [
] ( : Online), and then print to the currently loaded paper forcibly. If you are using the multi-
purpose tray, the setting for [MP Tray Paper Size] in the [Select Feeder] menu automatically changes to
the paper size specified in the application.
<Cause 2> The paper size specified in the application software is different from the following setting.
[MP Tray Paper Size], [Drawer 1 Size], [Drawer 2 Size] or [Drawer 3 Size] in the [Select Feeder] menu
Solution
Specify the setting properly.
"Registering the Paper Size"
<Cause 3> Improper paper source is selected.
Solution
Specify the setting for [Paper Source] in the [Select Feeder] menu properly.
"[Select Feeder] Menu"
IMPORTANT
When the message <Set below paper.> appears
If the front cover is opened, the message may disappear. However, be sure to follow the directions
in the displayed message to change the paper.
Syntax error.
<Cause> Invalid data is sent when printing using the UFR II printer driver.
Solution 1
Press [
] ( : Online) to continue printing from the next data. However, the page with which an error
is occurring and its subsequent pages are not printed.
Solution 2 Confirm the data to be printed, and then print again.
Turn OFF main power. Check options.
<Cause 1> The optional paper feeder is not installed properly.
Solution
Turn the power OFF, install the paper feeder properly, and then turn it ON again.
"Printer Installation"
<Cause 2> Any optional paper feeder is installed or removed when the printer is ON.
Solution
Turn the power OFF, install or remove the paper feeder, and then turn the printer ON again.
"Printer Installation"
<Cause 3> The connector of the optional paper feeder is disconnected.
Solution
Turn the printer OFF, unplug the power plug from the AC power outlet and contact your local authorized
Canon dealer for servicing.
㻥㻜㻟㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
