9-22
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 9 Vendor-Specific Management Information Base
Hewlett Packard MIBs
CPU Fan CPQHLTH-MIB
1.3.6.1.4.1.232.6.2.6.5
cpqHeThermalCpuFan
Status
Clearing Value = 2
This value will be one of the following:
• other(1) Fan status detection is not
supported by this system or driver.
• ok(2) The fan is operating properly.
• degraded(2) A redundant fan is not
operating properly.
• failed(4) A non-redundant fan is
not operating properly.
Network Interface
Card (NIC)
CPQNIC-MIB
1.3.6.1.4.1.232.18.2.3.1.1.13
cpqNicIfPhysAdapter
State
Clearing Value = 2 and 3
The following values are valid—
• unknown(1) The instrument agent
was not able to determine the status
of the adapter. The instrument
agent may need to be upgraded.
• ok(2) The physical adapter is
operating properly.
• generalFailure(3) The physical
adapter has failed.
• linkFailure(4) The physical adapter
has lost link. Check the cable
connections to this adapter.
Thermal CPQHLTH-MIB
1.3.6.1.4.1.232.6.2.6.1
cpqHeThermalCondition
Clearing Value = 2
This value will be one of the following:
• other(1) Temperature could not be
determined.
• ok(2) The temperature sensor is
within normal operating range.
• degraded(3) The temperature
sensor is outside of normal
operating range.
• failed(4) The temperature sensor
detects a condition that could
permanently damage the system.
Note The system automatically shuts
down if the failed (4) condition
occurs, so it is unlikely that 4
will ever be returned by the
agent. If the
cpqHeThermalDegradedAction
is set to shut down (3), the
system will shut down if the
condition occurs.
Table 9-13 HP Hardware Status Messages, MIBs and OIDs, MIB Object Names and Clearing Values, and
Object Responses (continued)
Cisco Unified CM Release 6.x
MCS-78xx Status MIB and OID
MIB Object Name and
Clearing Value Object Response
To Next Page
Loading...
