Cisco MDS 9000 Series Configuration Guide

Renaming Zones, Zone Sets, and Aliases Using Fabric Manager
To rename a zone, zone set, or alias using Fabric Manager, follow these steps:
Step 1 Choose Zone > Edit Local Full Zone Database.
You see the Select VSAN dialog box.
Step 2 Select a VSAN and click OK.
You see the Edit Local Full Zone Database dialog box for the selected VSAN (see Figure 36: Edit Local Full Zone
Database Dialog Box, on page 86).
Figure 36: Edit Local Full Zone Database Dialog Box
Step 3 Click a zone or zone set in the left pane.
Step 4 Choose Edit > Rename.
An edit box appears around the zone or zone set name.
Step 5 Enter a new name.
Step 6 Click Activate or Distribute.
Cloning Zones, Zone Sets, FC Aliases, and Zone Attribute Groups
To clone a zone, zoneset, fcalias, or zone-attribute-group, follow these steps:
Step 1 switch# configure terminal
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
86
Configuring and Managing Zones
Renaming Zones, Zone Sets, and Aliases Using Fabric Manager

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available