Cisco MDS 9000 Series

To enable full zoneset and active zoneset distribution to all switches on a per VSAN basis, follow these steps:
Step 1 switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# zoneset distribute full vsan 33
Enables sending a full zoneset along with an active zoneset.
Enabling Full Zoneset Distribution Using Fabric Manager
To enable full zone set and active zone set distribution to all switches on a per VSAN basis using Fabric
Manager, follow these steps:
Step 1 Expand a VSAN and select a zone set in the Logical Domains pane.
You see the zone set configuration in the Information pane. The Active Zones tab is the default.
Step 2 Click the Policies tab.
You see the configured policies for the zone (see Figure 28: Configured Policies for the Zone, on page 77).
Figure 28: Configured Policies for the Zone
Step 3 In the Propagation column, choose fullZoneset from the drop-down menu.
Step 4 Click Apply Changes to propagate the full zone set.
Enabling a One-Time Distribution
Use the zoneset distribute vsan vsan-id command in EXEC mode to perform this distribution.
switch# zoneset distribute vsan 2
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
77
Configuring and Managing Zones
Enabling Full Zoneset Distribution Using Fabric Manager