Cisco MDS 9000 Series

PurposeCommand
Displays the DPVM databases merge statistics.
switch# show dpvm merge statistics
switch(config)#
Clears the DPVM databases merge statistics.
switch(config)# clear dpvm merge statistics
switch(config)#
This example shows the conflicts in DPVM databases merge:
switch# show dpvm merge status
Last Merge Time Stamp : Fri Aug 8 15:46:36 2008
Last Merge State : Fail
Last Merge Result : Fail
Last Merge Failure Reason : DPVM DB conflict found during merge [cfs_status: 76] Last Merge
Failure Details: DPVM merge failed due to database conflict
Local Switch WWN : 20:00:00:0d:ec:24:e5:00
Remote Switch WWN : 20:00:00:0d:ec:09:d5:c0
--------------------------------------------------------------------------
Conflicting DPVM member(s) Loc VSAN Rem VSAN
--------------------------------------------------------------------------
dev-alias dpvm_dev_alias_1 [21:00:00:04:cf:cf:45:ba] 1313 1414
dev-alias dpvm_dev_alias_2 [21:00:00:04:cf:cf:45:bb] 1313 1414
dev-alias dpvm_dev_alias_3 [21:00:00:04:cf:cf:45:bc] 1313 1414
[Total 3 conflict(s)]
rbadri-excal13#
This example shows the conflicts in DDAS mode:
switch# show dpvm merge status
Last Merge Time Stamp : Fri Aug 8 15:46:36 2008
Last Merge State : Fail
Last Merge Result : Fail
Last Merge Failure Reason : DPVM DB conflict found during merge [cfs_status: 76] Last Merge
Failure Details: DPVM merge failed due to DDAS mode conflict
Local Switch WWN : 20:00:00:0d:ec:24:e5:00
Remote Switch WWN : 20:00:00:0d:ec:09:d5:c0
Local DDAS mode : Basic
Remote DDAS mode : Enhanced
Displaying DPVM Configurations
Use the show dpvm command to display information about WWNs configured on a per VSAN basis (see the
following examples).
Displays the DPVM Configuration Status
switch# show dpvm status
DB is activated successfully, auto-learn is on
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
31
Creating Dynamic VSANs
Displaying DPVM Configurations