Step 2 switch(config)# interface fc1/4
switch(config-if)#
Configures the specified interface, or if already configured, enters configuration mode for the specified interface.
Step 3 switch(config-if)# fspf retransmit-interval 15 vsan 12
switch(config-if)#
Specifies the retransmit time interval for unacknowledged link state updates in VSAN 12. The default is 5 seconds.
About Disabling FSPF for Specific Interfaces
You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and TE
ports. This default can be disabled by setting the interface as passive.
FSPF must be enabled at both ends of the interface for the protocol to work.
Note
Disabling FSPF for Specific Interfaces
You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and TE
ports. This default can be disabled by setting the interface as passive.
To disable FSPF for a specific interface, follow these steps:
Step 1 switch# config terminal
switch(config)#
Enters configuration mode.
Step 2 switch(config)# interface fc1/4
switch(config-if)#
Configures a specified interface, or if already configured, enters configuration mode for the specified interface.
Step 3 switch(config-if)# fspf passive vsan 1
switch(config-if)#
Disables the FSPF protocol for the specified interface in the specified VSAN.
Step 4 switch(config-if)# no fspf passive vsan 1
switch(config-if)#
Reenables the FSPF protocol for the specified interface in the specified VSAN.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
193
Configuring Fibre Channel Routing Services and Protocols
About Disabling FSPF for Specific Interfaces
To Next Page
Loading...
Need help?
General
