Cisco MDS 9000 Series

Enters configuration mode.
Step 2 switch(config)# fspf enable vsan 7
Enables the FSPF routing protocol in VSAN 7.
Step 3 switch(config)# no fspf enable vsan 5
Disables the FSPF routing protocol in VSAN 5.
Clearing FSPF Counters for the VSAN
To clear the FSPF statistics counters for the entire VSAN, follow this step:
switch# clear fspf counters vsan 1
Clears the FSPF statistics counters for the specified VSAN. If an interface reference is not specified, all counters are
cleared.
FSPF Interface Configuration
Several FSPF commands are available on a per-interface basis. These configuration procedures apply to an
interface in a specific VSAN.
This section includes the following topics:
About FSPF Link Cost
FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database, and
then chooses the path with a minimal cost. The cost associated with an interface can be administratively
changed to implement the FSPF route selection. The integer value to specify cost can range from 1 to 30000.
The default cost for 1 Gbps is 1000 and for 2 Gbps is 500.
Configuring FSPF Link Cost
To configure FSPF link cost, follow these steps:
Step 1 switch# config t
switch(config)#
Enters configuration mode.
Step 2 switch(config)# interface fc1/4
switch(config-if)#
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
190
Configuring Fibre Channel Routing Services and Protocols
Clearing FSPF Counters for the VSAN