Cisco MDS 9000 Series Configuration Guide

Displays the VSAN Usage
switch# show vsan usage
4 vsan configured
configured vsans:1-4
vsans available for configuration:5-4093
Displays All VSANs
switch# show vsan
vsan 1 information
name:VSAN0001 state:active
in-order guarantee:no interoperability mode:no
loadbalancing:src-id/dst-id/oxid
vsan 2 information
name:VSAN0002 state:active
in-order guarantee:no interoperability mode:no
loadbalancing:src-id/dst-id/oxid
vsan 7 information
name:VSAN0007 state:active
in-order guarantee:no interoperability mode:no
loadbalancing:src-id/dst-id/oxid
vsan 100 information
name:VSAN0100 state:active
in-order guarantee:no interoperability mode:no
loadbalancing:src-id/dst-id/oxid
vsan 4094:isolated vsan
Default Settings
Table 3: Default VSAN Parameters , on page 19 lists the default settings for all configured VSANs.
Table 3: Default VSAN Parameters
DefaultParameters
VSAN 1.Default VSAN
Active state.State
Concatenation of VSAN and a four-digit string representing the VSAN ID. For
example, VSAN 3 is VSAN0003.
Name
OX ID (src-dst-ox-id).Load-balancing attribute
Displaying Fabric Switch Information
Use the show fabric switch information vsan command to display information about each switch in the
fabric in the given VSAN.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
19
Configuring and Managing VSANs
Default Settings

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available