Cisco MDS 9000 Series Configuration Guide

Step 3 switch(config)# no fcflow stats aggregated module 1 index 1005 vsan 1
switch(config)#
Disables the aggregated flow counter.
Counting Individual Flow Statistics
To count the flow statistics for a source and destination FC ID in a VSAN, follow these steps:
Step 1 switch# config t
switch(config)#
Enters configuration mode.
Step 2 switch(config)# fcflow stats module 1 index 1 0x145601 0x5601ff 0xffffff vsan 1
switch(config)#
Enables the flow counter.
The source ID and the destination ID are specified in FC ID hex format (for example, 0x123aff). The mask can
be one of 0xff0000 or 0xffffff.
Note
Step 3 switch(config)# no fcflow stats aggregated module 2 index 1001 vsan 2
switch(config)#
Disables the flow counter.
Clearing FIB Statistics
Use the clear fcflow stats command to clear the aggregated flow counter (see Examples Clears Aggregated
Flow Counters, on page 201 and Clears Flow Counters for Source and Destination FC IDs, on page 201).
Clears Aggregated Flow Counters
switch# clear fcflow stats aggregated module 2 index 1
Clears Flow Counters for Source and Destination FC IDs
switch# clear fcflow stats module 2 index 1
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
201
Configuring Fibre Channel Routing Services and Protocols
Counting Individual Flow Statistics

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available