Cisco MDS 9000 Series

Displays the DPVM Current Dynamic Ports for the Specified VSAN
switch# show dpvm ports vsan 10
--------------------------------------------------------------
Interface Vsan Device pWWN Device nWWN
--------------------------------------------------------------
fc1/2 10 29:a0:00:05:30:00:6b:a0 fe:65:00:05:30:00:2b:a0
Displays the DPVM Config Database
switch# show dpvm database
pwwn 11:22:33:44:55:66:77:88 vsan 11
pwwn 22:22:33:44:55:66:77:88 vsan 22
pwwn 33:22:33:44:55:66:77:88 vsan 33
pwwn 44:22:33:44:55:66:77:88 vsan 44
[Total 4 entries]
Displays the DPVM Database
switch# show dpvm database active
pwwn 11:22:33:44:55:66:77:88 vsan 22
pwwn 22:22:33:44:55:66:77:88 vsan 22
pwwn 33:22:33:44:55:66:77:88 vsan 33
[Total 3 entries]
* is auto-learnt entry
Displays DPVM Config Database
switch# show dpvm database
pwwn 11:22:33:44:55:66:77:88 vsan 11
pwwn 22:22:33:44:55:66:77:88 vsan 22
pwwn 33:22:33:44:55:66:77:88 vsan 33
pwwn 44:22:33:44:55:66:77:88 vsan 44
[Total 4 entries]
Compares Pending Database with the DPVM Config Database
switch# show dpvm pending-diff
Legend: “+” New Entry, “-” Missing Entry, “*” Possible Conflict Entry
---------------------------------------------------------------------
+ pwwn 55:22:33:44:55:66:77:88 vsan 55
- pwwn 11:22:33:44:55:66:77:88 vsan 11
* pwwn 44:22:33:44:55:66:77:88 vsan 44
Sample DPVM Configuration
To configure a basic DPVM scenario, follow these steps:
Step 1 Enable DPVM and enable DPVM distribution.
Example:
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
32
Creating Dynamic VSANs
Sample DPVM Configuration