Step 3 Select the members you want to add from the Fabric pane (see Figure 17: Edit Local Full Zone Database Dialog Box, on
page 59) and click Add to Zone or click the zone where you want to add members and click the Insert icon.
You see the Add Member to Zone dialog box (see Figure 18: Add Member to Zone Dialog Box, on page 60).
Figure 18: Add Member to Zone Dialog Box
The Device Alias radio button is visible only if device alias is in enhanced mode. For more information, see
Creating Device Aliases section.
Note
Step 4 Click the browse button and select a port name or check the LUN check box and click the browse button to configure
LUNs.
Step 5 Click Add to add the member to the zone.
When configuring a zone member, you can specify that a single LUN has multiple IDs depending on the
operating system. You can select from six different operating systems
Note
Filtering End Devices Based on Name, WWN or FC ID
To filter the end devices and device aliases, follow these steps:
Step 1 Click the Zone icon in the toolbar (see Figure 12: Zone Icon, on page 57).
Step 2 Select Name, WWN or FC ID from the With drop-down list.
Step 3 Enter a filter condition, such as *zo1*, in the Filter text box.
Step 4 Click Go.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
60
Configuring and Managing Zones
Filtering End Devices Based on Name, WWN or FC ID