Removes the device type configuration for all the members of the zone and fcalias of all the specified zonesets in the
VSAN.
Disabling Smart Zoning at Zone Level in the Basic Zoning Mode
To disable smart zoning at the zone level for a VSAN in basic zoning mode, follow these steps:
Step 1 switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# zone name zone1 vsan 1
Configures a zone name.
Step 3 switch(config-zone)# attribute disable-smart-zoning
Disables Smart Zoning for the selected zone.
This command only disables the smart zoning for the selected zone and does not remove the device type
configurations.
Note
Disabling Smart Zoning at Zone Level for a VSAN in the Enhanced Zoning
Mode
To disable smart zoning at the zone level for a VSAN in enhanced zoning mode, follow these steps:
Step 1 switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# zone-attribute-group name disable-sz vsan 1
Creates an enhanced zone session.
Step 3 switch(config-attribute-group)#disable-smart-zoning
Disables Smart Zoning for the selected zone.
This command only disables the smart zoning for the selected zone and does not remove the device type
configurations.
Note
Step 4 switch(config-attribute-group)# zone name prod vsan 1
Configures a zone name.
Step 5 switch(config-zone)# attribute-group disable-sz
Configures to assign a group-attribute name for the selected zone.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
99
Configuring and Managing Zones
Disabling Smart Zoning at Zone Level in the Basic Zoning Mode
To Next Page
Loading...
Need help?
General
