Cisco MDS 9000 Series Configuration Guide

--------------------------------------------------------------------------
FCID TYPE PWWN (VENDOR) FC4-TYPE:FEATURE
--------------------------------------------------------------------------
0x9c0000 N 21:00:00:e0:8b:08:96:22 (Company 1) scsi-fcp:init
0x9c0100 N 10:00:00:05:30:00:59:1f (Company 2) ipfc
0x9c0200 N 21:00:00:e0:8b:07:91:36 (Company 3) scsi-fcp:init
0x9c03d6 NL 21:00:00:20:37:46:78:97 (Company 4) scsi-fcp:target
Configuring Device Types for Zone Members
To configure the device types for zone members, follow these step:
Step 1 switch# configure terminal
Enters configuration mode.
Step 2 switch(config-zoneset-zone)# member device-alias name both
Configures the device type for the device-alias member as both. For every supported member-type, init, target, and both
are supported.
Step 3 switch(config-zoneset-zone)# member pwwn number target
Configures the device type for the pwwn member as target. For every supported member-type, init, target, and both are
supported.
Step 4 switch(config-zoneset-zone)# member fcid number
Configures the device type for the FCID member. There is no specific device type that is configured. For every supported
member-type, init, target, and both are supported.
When there is no specific device type configured for a zone member, at the backend, zone entries that are
generated are created as device type both.
Note
Removing Smart Zoning Configuration
To remove the smart zoning configuration, follow this steps:
Step 1 switch(config)# clear zone smart-zoning fcalias name alias-name vsan number
Removes the device type configuration for all the members of the specified fcalias.
Step 2 switch(config)# clear zone smart-zoning zone name zone name vsan number
Removes the device type configuration for all the members of the specified zone.
Step 3 switch(config)# clear zone smart-zoning zoneset name zoneset name vsan number
Removes the device type configuration for all the members of the zone and fcalias for the specified zoneset.
Step 4 switch(config)# clear zone smart-zoning vsan number
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
98
Configuring and Managing Zones
Configuring Device Types for Zone Members

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available