Cisco MDS 9000 Series Configuration Guide

Smart Zoning Member Configuration
Table displays the supported smart zoning member configurations.
Table 7: Smart Zoning Configuration
SupportedFeature
YesPWWN
YesFCID
YesFCalias
YesDevice-alias
NoInterface
NoIP address
NoSymbolic nodename
NoFWWN
NoDomain ID
Enabling Smart Zoning on a VSAN
To configure the smart zoning for a VSAN, follow these steps:
Step 1 switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# zone smart-zoning enable vsan 1
Enables smart zoning on a VSAN.
Step 3 switch(config)# no zone smart-zoning enable vsan 1
Disables smart zoning on a VSAN.
Setting Default Value for Smart Zoning
To set the default value, follow these steps:
Step 1 switch# configure terminal
Enters configuration mode.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
96
Configuring and Managing Zones
Smart Zoning Member Configuration

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available