EasyManuals Logo

Cisco MDS 9000 Series Configuration Guide

Cisco MDS 9000 Series
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
Figure 40: Modify Default Zone Properties Dialog Box
Step 4 Set the Policy drop-down menu to permit to permit traffic in the default zone, or set it to deny to block traffic in the
default zone.
Step 5 Click OK to save these changes.
About Broadcast Zoning
Broadcast zoning is not supported on the Cisco Fabric Switch for HP c-Class BladeSystem and the Cisco
Fabric Switch for IBM BladeCenter.
Note
You can configure broadcast frames in the basic zoning mode. By default, broadcast zoning is disabled and
broadcast frames are sent to all Nx ports in the VSAN. When enabled, broadcast frames are only sent to Nx
ports in the same zone, or zones, as the sender. Enable broadcast zoning when a host or storage device uses
this feature.
Table identifies the rules for the delivery of broadcast frames.
Table 6: Broadcasting Requirements
CommentsFrames
Broadcast?
Broadcast Enabled?Active
Zoning?
Broadcast to all Nx ports that share a broadcast
zone with the source of broadcast frames.
YesYesYes
Broadcast to all Nx ports.YesYesNo
Broadcasting is disabled.NoNoYes
If any NL port attached to an FL port shares a broadcast zone with the source of the broadcast frame, then the
frames are broadcast to all devices in the loop.
Tip
If broadcast zoning is enabled on a switch, you cannot configure the interop mode in that VSAN.
Caution
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
93
Configuring and Managing Zones
About Broadcast Zoning

Table of Contents

Other manuals for Cisco MDS 9000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco MDS 9000 Series and is the answer not in the manual?

Cisco MDS 9000 Series Specifications

General IconGeneral
CategorySwitch
Operating SystemCisco NX-OS
PortsVaries by model
ProtocolsFibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
RedundancyRedundant supervisors, power supplies, and fans
ManagementCisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization SupportVSANs (Virtual SANs)
Security FeaturesFibre Channel Security Protocol (FC-SP)
Hot Swappable Componentspower supplies, fans
Power Supply OptionsAC and DC options available

Related product manuals