Displaying the Configured FICON State
If FICON is enabled on a VSAN, you can display the port address information for that VSAN (see Displays
the Specified Port Address When FICON Is Enabled, on page 294).
Displays the Specified Port Address When FICON Is Enabled
switch# show ficon
vsan 2 portaddress 55
Port Address 55 is not installed in vsan 2
Port number is 55, Interface is fc2/23
Port name is
Port is not admin blocked
Prohibited port addresses are 0,241-253,255
Admin port mode is FL
Port mode is FL, FCID is 0xea0000
Displaying a Port Administrative State
Examples Displays an Administratively Unblocked Port , on page 294 to Displays an Administratively
Unblocked Port , on page 294 display the administrative state of a FICON port. If the port is blocked, the show
ficon vsan number portaddress number command displays the blocked state of the port. If a specific port is
prohibited, this command also displays the specifically prohibited port (3) along with the ports that are
prohibited by default (0, 241 to 253, and 255). If a name is assigned, that name is also displayed.
Displays an Administratively Unblocked Port
switch# show ficon vsan 2 portaddress 2
Port Address 2(0x2) is not installed in vsan 2
Port number is 2(0x2), Interface is fc1/2
Port name is
Port is not admin blocked
Prohibited port addresses are 0,241-253,255(0,0xf1-0xfd,0xff)
Admin port mode is auto
Peer is Unknown
Displays an Administratively Blocked Port
switch# show ficon vsan 2 portaddress 1
Port Address 2(0x2) is not installed in vsan 2
Port number is 2(0x2), Interface is fc1/2
Port name is SampleName
Port is admin blocked
Prohibited port addresses are 0,241-253,255(0,0xf1-0xfd,0xff)
Admin port mode is auto
Peer is Unknown
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
294
Configuring FICON
Displaying the Configured FICON State
To Next Page
Loading...
Need help?
General
