Cisco MDS 9000 Series

Displays the Startup Configuration
switch# show startup-config
...
ficon vsan 2
file IPL
Displays the Startup Configuration Status, on page 297 displays the switch response to an
implicitly-issued copy running start command. In this case, only a binary configuration is saved until
you explicitly issue the copy running start command again (seeTable 23: Saving the Active FICON
and Switch Configuration , on page 268 )
Displays the Startup Configuration Status
switch# show startup-config
No ASCII config available since configuration was last saved internally
on account of 'active=saved' mode.
Please perform an explicit 'copy running startup` to get ASCII configuration
Displaying FICON-Related Log Information
Displays Logging Levels for the FICON Feature, on page 297 and Displays FICON-Related Log File Contents,
on page 297 display the logging information for FICON-related configurations.
Displays Logging Levels for the FICON Feature
switch# show logging level ficon
Facility Default Severity Current Session Severity
-------- ---------------- ------------------------
ficon 2 2
0(emergencies) 1(alerts) 2(critical)
3(errors) 4(warnings) 5(notifications)
6(information) 7(debugging)
Displays FICON-Related Log File Contents
switch# show logging logfile
...
2004 Feb 25 15:38:50 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 13:22:04.
131183%$ Interface fc1/8 is up in mode F
2004 Feb 25 15:38:50 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 13:22:04.
131217%$ Interface fc1/9 is up in mode F
...
2004 Feb 25 15:39:09 vegas6 %PORT-5-IF_TRUNK_UP: %$VSAN 75: 2004 Wed Feb 25 13:
22:23.131121%$ Interface fc2/1, vsan 75 is up
2004 Feb 25 15:39:09 vegas6 %PORT-5-IF_TRUNK_UP: %$VSAN 75: 2004 Wed Feb 25 13:
22:23.131121%$ Interface fc2/2, vsan 75 is up
2004 Feb 25 15:39:09 vegas6 %PORT-5-IF_TRUNK_UP: %$VSAN 75: 2004 Wed Feb 25 13:
...
2004 Feb 25 23:22:36 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 21:05:42.
99916%$ Interface fc3/6 is up in mode F
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
297
Configuring FICON
Displaying FICON-Related Log Information