Cisco MDS 9000 Series Configuration Guide

switch# autozone
This command will create and activate single-initiator and single-target zones for all
end-devices are already logged-in automatically; that may lead to more tcam entries and
also RSCN load on network. Please use AutoZone judiciously.
AutoZone feature is enabled
Device with pwwn 10:00:00:de:fb:74:e8:31 is not registered with FC4-type Init or Target.
Hence, it will be ignored for AutoZone configuration.
Configuring zones for vsan 1
AUTOZONE_JPG21190082_1
Configuring zoneset for vsan 1
Activating the zoneset. Please wait...
Configured zoneset AUTOZONESET for vsan 1 successfully.
The following example shows how to execute the Autozone feature once to zone all the unzoned
devices logged in on VSAN 1, and add them to the active zoneset of VSAN 1 without creating the
Autozone scheduler job. A device without a suitable FC4 type is detected and not included in the
zone configuration.
switch# autozone --update
Device with pwwn 10:00:00:de:fb:74:e8:31 is not registered with FC4-type Init or Target.
Hence, it will be ignored for AutoZone configuration.
Configuring zones for vsan 1
AUTOZONE_JPG21190082_1
AUTOZONE_JPG21190082_2
AUTOZONE_JPG21190082_3
AUTOZONE_JPG21190082_4
Configuring zoneset for vsan 1
Activating the zoneset. Please wait...
Configured zoneset AUTOZONESET for vsan 1 successfully.
The following example shows how to disable the Autozone feature so that newly logged-in devices
are not zoned while retaining the existing zone configuration:
switch# autozone --disable
This will disable the AutoZone feature. Do you wish to continue? [n]|y: y
AutoZone feature disabled successfully.
The following example shows how to delete the Autozone and zoneset created for VSAN 1:
switch# autozone --delete
Checking if zoneset name AUTOZONESET present on switch...[Found]
Checking if AutoZone is enabled on switch...[Disabled]
This option will only delete the zone/zoneset configurations done by AutoZone feature.
Do you wish to continue? [n]|y: y
Deleting zoneset name AUTOZONESET and all zones for vsan 1 configured by AutoZone
Deleting following zones -
AUTOZONE_JPG21190082_1
AUTOZONE_JPG21190082_2
AUTOZONE_JPG21190082_3
AUTOZONE_JPG21190082_4
Deactivating zoneset for vsan 1.
Deactivated zoneset for vsan 1.
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
48
Configuring and Managing Zones
Example: Configuring Autozone

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available