Cisco MDS 9000 Series

Configures a zone called Zone1 for the VSAN called vsan3.
All alphanumeric characters or one of the following symbols ($, -, ^, _) are supported.
Note
Step 3 switch(config-zone)# member type value
Example:
pWWN example:
Example:
switch(config-zone)# member pwwn 10:00:00:23:45:67:89:ab
Example:
Fabric pWWN example:
Example:
switch(config-zone)# member fwwn 10:01:10:01:10:ab:cd:ef
Example:
FC ID example:
Example:
switch(config-zone)# member fcid 0xce00d1
Example:
FC alias example:
Example:
switch(config-zone)# member fcalias Payroll
Example:
Domain ID example:
Example:
switch(config-zone)# member domain-id 2 portnumber 23
Example:
IPv4 address example:
Example:
switch(config-zone)# member ip-address 10.15.0.0 255.255.0.0
Example:
IPv6 address example:
Example:
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
55
Configuring and Managing Zones
Configuring a Zone