CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : Menu overview
207
Automatic load/unload
This menu allows to set the parameters concerning automatic load/unload as described in §13.13.
Parameter
[var.num]
Possible value
Comment
Load/Unl. mode
[E1258]
Inhibited [0]
No start/stop gensets according to the load demand
GE number [1]
Start/stop sequence will be done by the genset number
Hours run [2]
Start/stop will be done according to the GENSYS 2.0 hour
meter
Var. E1617 [3]
(1)
Start/stop sequence will follow the priority number set in
each unit in the variable [E1617]
Load threshold
[E1256]
Percentage of the genset nominal power at which GENSYS
2.0 will ask another genset to start and share the load.
Unload thresh.
[E1254]
Timer for load sharing request.
TM before load
[E1257]
Percentage of the genset nominal power at which GENSYS
2.0 will ask a genset to stop sharing the load.
TM bef. unload
[E1255]
Timer used before deciding to reduce the number of gensets
in load/unload management.
Table 82 - Automatic load/unload Configuration
(1) Only available on level 2
Load dep stop
This menu is only available in level 2. It allows to set the parameters used for the unload dependant stop
sequence. (See §13.13 for more details)
Parameter
[var.num]
Possible value
Comment
Unload dep stp
[E1914]
No [0]
Select or deselect the unload dependant stop sequence
Yes[1]
Unload dp. thrs
[E1915]
Percentage of the genset nominal power (compute if the
generator stop) at which GENSYS 2.0 will ask to stop sharing
the load.
Table 83 - Load dep stop Configuration

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English