CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : Menu overview
213
J1939/MDEC
Parameter
[var.num]
Comment
Manufacturer
[E4034]
Manufacturer selection to communicate on COM2 by J1939 (See
§15.3.2 for more details).
ECU type
[E4068]
ECU selection to communicate on COM2 by J1939 (See §15.3.2 for
more details).
CT J1939 Fault
[E4080]
(1)
Control when a CAN bus fault occurred (See §12 for more details).
Table 95 - J1939/MDEC configuration
(1) Only available on level 2
If an ECU has been selected, it’s possible to configure the engine protections according to the information
received by J1939.
Parameter
[var.num]
Comment
CT speed +
[E1857]
Protection associated to a high speed.
CT speed ++
[E1862]
Protection associated to a very high speed.
CT Cool Temp+
[E1859]
Protection associated to a high water temperature.
CT Cool Temp++
[E1861]
Protection associated to a very high water temperature.
CT Oil Press –
[E1858]
Protection associated to a low oil pressure.
CT Oil Press – –
[E1860]
Protection associated to a very low oil pressure.
CT Malfunction
[E1863]
Protection associated to an emission-related trouble code active.
CT Protection
[E1864]
Protection associated to a problem with an engine system that is
most probably not electronic subsystem related. For instance,
engine coolant temperature is exceeding its prescribed
temperature range.
CT Orange
[E1865]
Protection associated to a problem with the engine system where
the engine need not be immediately stopped.
CT Red
[E1866]
Protection associated to a severe enough condition that it
warrants stopping the engine.
Table 96 – J1939 protection configuration

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English