CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : Menu overview
234
17.4.9 Update firmware
This menu is only available in level 2 and on computer.
It allows to update the software with the latest version. (See §15.7.2 for more details)
17.4.10 Reset factory setting
This menu is only available in level 2.
It resets the factory settings of the module : parameters, labels, equations,… ( see §14.8 for more details)
17.4.11 About
This menu displays some information on module and on Ethernet connection.
 Serial number
 Software version
 Boot software version
 Module name
 IP address
 Gateway IP address
 MAC address
 DHCP status
 Copyright for lwip (See §15.5.2)
17.5 Dedicated screens
The dedicated screens are :
 The faults page
 The alarms page
 The information page.
17.5.1 FauLts
At any time and any level, you can click on the "Faults" link on your browser or press the [FAULT] key on
the front panel. Click BACK on your internet browser or press the button a second time to return to your
previous screen.
The last 50 faults will be display as follows:
dd/mm/yy hh:mn:ss protec. label XXXX=On (or Off). XXXX is the variable number.
By pressing "<<" or ">>", you can change between the active faults, 1
st
to 10
th
faults, 11
th
to 20
th
faults...

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English