CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : Menu overview
221
17.3.10 Control loop
1/ kW control
kW sharing loop
This menu allows to set the kW sharing PID when the generator share the load with other generators. (See
§13.12 for more details on PID)
Parameter
[var.num]
Comment
G
[E1102]
Global gain of kW sharing
Table 107 – kW sharing loop PID configuration
While you adjust the PID settings, the following parameters are displayed:
 Generator active and reactive power (P et Q),
 Engine speed,
 Generator voltage (phase 1),
 Frequency,
 Sum of the speed output (en %).
Ramp/Constant kW
This menu allows to set the power management PID when one generator is paralleled with mains. (See
§13.12 for more details on PID)
Parameter
[var.num]
Comment
G
[E1099]
Gloabl gain of ramp/constant kW
I
[E1101]
Integral of ramp/constant kW
Table 108 - Ramp/constant kW PID configuration
While you adjust the PID settings, the following parameters are displayed:
 Generator active and reactive power (P et Q),
 Engine speed,
 Generator voltage (phase 1),
 Frequency,
 Sum of the speed output (en %).

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English