CRE Technology GENSYS 2.0 - Table 5 - Control Panel Keys

A53 Z0 9 0020 L En Technical documentation
Chapter : Description
21
4.1.3 Control panel
The control panel allows the user to pilot and control the generator. See chapter “User interface” for more
details concerning the functions of front panel LED and keys.
Key
Function
upper
right
LED
2.0
This LED is illuminated when a key is pressed and is switched off when all keys
are released. This LED also stays on during a save parameters command (see
SHIFT-I above). It is also used to indicate SD card accesses.
Auto
Switches the system to automatic mode. The associated LED is ON when AUTO
mode is activated.
Test
Switches the system to test mode. The associated LED is ON when TEST mode
is activated.
Manu
Switches the system to manual mode. The associated LED is ON when MANU
mode is activated.
Start
Starts the generator (only available in manual mode).
Stop
Stops the generator (only in manual mode).
O/I
Closes/opens the generator breaker (only in manual mode).
O/I
Closes/opens the mains breaker if available (only in manual mode).
Table 5 – Control panel keys