CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : User interface
35
5.3.2 GENSYS 2.0 internal Web server
 Connect GENSYS 2.0 to your computer using an Ethernet cross over cable.
 Start your Web browser (Ex: Firefox or Internet Explorer).
 Type in the GENSYS 2.0 URL or IP address (factory settings http://gensys or http://192.168.11.1)
according to your GENSYS 2.0 and Windows hosts file settings.
 GENSYS 2.0 password page appears. Enter your password to browse GENSYS 2.0 Web site.
Note: Parameter [E4042] serves as a Web connection timeout delay. Once this time is elapsed without any
Web communication, the password will be asked for again.
GENSYS 2.0 internal Web server is a very easy and efficient way of setting up your module. Various menus
can be accessed via a Web browser such as Firefox or Internet Explorer as shown in the screenshots below.
Figure 11 - Typical GENSYS 2.0 Web pages
Left page shown above gives access to 6 subpages (“Protections” for example). Right page shows different
kinds of parameters (numerical values, list of choice) that can be modified and then sent back to the
module using Save button.
Web links << and >> give access to other pages of the current menu, Esc link leads back to the upper level
menu.
Bottom links are identical to the Fault / Alarm / Information keys on the GENSYS 2.0 front panel.

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English