CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : Menu overview
229
4/ COM4 (ETHERNET)
This menu allows configuring the Ethernet connection to communicate with a PC. Please contact your
network administrator to configure router and module(s) according to your need.
Parameter
[var.num]
Possible value
Comment
Use DHCP
[E4065]
Disable [0]
Enable the DHCP protocol (dynamic IP address) or disable (fix
IP address)
Enable [1]
IP Address
[E4010] à [E4013]
(1)
Configure fix IP address of the unit (DHCP disable or in fault)
IP GW address
[E4026] à [E4029]
(1)
Configure gateway IP address (DHCP disable)
TCP
[E4081]
TCP communication port
UDP
[E4082]
UDP communication port
Modbus TCP
[E4083]
Modbus TCP communication port
Table 119 – Ethernet configuration
(1) Only available if DHCP protocol is disabled.
Note: modifications on these parameters are taken into account during power on sequence. So it is
necessary to restart your module in order to use the new configuration.
5/ COM5 (RS485: MODBUS RTU)
This menu allows setting up Modbus RTU. (See §15.6 for more details)
Parameter
[var.num]
Comment
Modbus address
[E1634]
Define the GENSYS 2.0 Modbus SLAVE (RTU) address.
Modbus speed
[E1441]
The following speeds are available: 4800, 9600, 19200bps.
Modbus rights
(1)(2)
[E4107]
Allows defining the Modbus access rights access to the
parameters.
LCD menu gives access to the following predefined settings:
Factory/Full access/Standard TCP – No RTU/Standard RTU – No
TCP/No access.
Web site menu gives access to fully customizable settings as
described below.
Table 120 – Modbus configuration
(1) Only available with password level 2.
(2) On the computer, you will have access to check boxes in order to create your own configuration.

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English