CRE Technology GENSYS 2.0 User Manual

A53 Z0 9 0020 L En Technical documentation
Chapter : Communication
188
15.7 COM6: SD card
GENSYS 2.0 is equipped with a SD card slot that adds different functions using a FLASH memory SD card.
 backup
 Firmware upgrade
 Import/Export a text file
Table below details what kind of SD card can be used depending on firmware version installed into your
module. To check your firmware version, go into menu « System / About » or « System / Serial
number/Soft version ».
Supported cards and file systems depending on firmware version
Firmware versions 4.00 and above can accept SD and SDHC cards formatted
using FAT16 or FAT32 file systems.
Firmwares older than v4.00 only accept SD cards up to 2 GB formatted using
FAT16 file system.
High capacity SDHC cards (cards above 2 GB) and cards formatted using FAT32
file system are not supported.
15.7.1 Backup using SD Cards
The SD card must contain a file named logger.csv. CSV (Comma separated value) is a computer file format
which shows tables in the form of values separated by commas or semi-colons.
This file can be created using Microsoft Excel or the notepad: open the notepad, then write the names of
the variables you wish to save (max 25) using the Exxxx format. Separate each variable with a comma and
save the file as logger.csv.

CRE Technology GENSYS 2.0 Specifications

General

Brand	CRE Technology
Model	GENSYS 2.0
Category	Control Unit
Language	English