305
M5.0-1055-007
02 Rev. 2/09
BRAKE
Brake
9. Install replacement brake assembly, keeping brake
hub in position. Refer to Figure 16941-01.
10. Brake electrical leads should be pointing upwards.
11. Secure brake assembly using screws removed in
step 6 and torque to 9.5 ± 1.0 Nm (7.0 ± 1.0 ft lb).
Refer to Figure 16941-01.
12. Remove three screws installed in step 5.
13. Repeat the above steps for remaining parking
brake assembly.
14. Connect battery, key truck ON and raise mast to
allow removal of blocking material.
15. Lower mast and verify parking brake operation.
Figure 16941-01
1 Mounts to Drive Unit
2 LH Traction Motor
3 Brake Assembly
4 Screws - Torque 9.5 ± 1.0 Nm (7.0 ± 1.0 ft lb)
Crown 2007 PF15692-7 Rev. 2/09
To Next Page
Loading...