Access Control Lists (ACLs) | 111
When you use the log keyword, CP processor logs details about the packets that match. Depending on how
many packets match the log entry and at what rate, the CP may become busy as it has to log these packets’
details.
To view the rules of a particular ACL configured on a particular interface, use the
show ip accounting
access-list
ACL-name interface interface command in EXEC Privilege mode as shown in the example
below.
FTOS#show ip accounting access ToOspf interface gig 1/6
Standard IP access list ToOspf
seq 5 deny any
seq 10 deny 10.2.0.0 /16
seq 15 deny 10.3.0.0 /16
seq 20 deny 10.4.0.0 /16
seq 25 deny 10.5.0.0 /16
seq 30 deny 10.6.0.0 /16
seq 35 deny 10.7.0.0 /16
seq 40 deny 10.8.0.0 /16
seq 45 deny 10.9.0.0 /16
seq 50 deny 10.10.0.0 /16
FTOS#
The example below illustrates how the seq command orders the filters according to the sequence number
assigned. In the example, filter 25 was configured before filter 15, but the
show config command displays
the filters in the correct order.
FTOS(config-std-nacl)#seq 25 deny ip host 10.5.0.0 any log
FTOS(config-std-nacl)#seq 15 permit tcp 10.3.0.0 /16 any
FTOS(config-std-nacl)#show config
!
ip access-list standard dilling
seq 15 permit tcp 10.3.0.0/16 any
seq 25 deny ip host 10.5.0.0 any log
FTOS(config-std-nacl)#
To delete a filter, use the no seq sequence-number command in the IP ACCESS LIST mode.
If you are creating a standard ACL with only one or two filters, you can let FTOS assign a sequence
number based on the order in which the filters are configured. The software assigns filters in multiples of 5.
Note: When assigning sequence numbers to filters, keep in mind that you might need to insert a
new filter. To prevent reconfiguring multiple filters, assign sequence numbers in multiples of five or
another number.
To Next Page
Loading...
