IPv6 Routing | 559
Figure 25-8. Command Example: show ipv6 route summary
Figure 25-9 illustrates the show ipv6 route static command output.
Figure 25-9. Command Example: show ipv6 route static
Show the Running-Configuration for an Interface
View the configuration for any interface with the following command.
Figure 25-10 illustrates the
show running-config command output. Note the IPv6 address listed.
Command Syntax Command Mode Purpose
show running-config
interface type {slot/port}
EXEC Show the currently running configuration for the
specified interface
Enter the keyword interface followed by the type of
interface and slot/port information:
• For a 10/100/1000 Ethernet interface, enter the
keyword GigabitEthernet followed by the slot/
port information.
• For a Gigabit Ethernet interface, enter the
keyword GigabitEthernet followed by the slot/
port information.
• For the Management interface on the RPM, enter
the keyword ManagementEthernet followed by
the slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
keyword TenGigabitEthernet followed by the
slot/port information.
• For a 40-Gigabit Ethernet interface, enter the
keyword fortyGigE followed by the slot/port
information.
FTOS#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 5 0
static 0 0
Total 5 0
FTOS#show ipv6 route static
Destination Dist/Metric, Gateway, Last Change
-----------------------------------------------------
S 8888:9999:5555:6666:1111:2222::/96 [1/0]
via 2222:2222:3333:3333::1, Gi 9/1, 00:03:16
S 9999:9999:9999:9999::/64 [1/0]
via 8888:9999:5555:6666:1111:2222:3333:4444, 00:03:16
To Next Page
Loading...
