Dell Force10 S4810P - BMP Mode: Boot and Set-Up Behavior

Bare Metal Provisioning 3.0 (BMP 3.0) | 263
• If there is a mismatch between the build images, the system upgrades to the downloaded version
and reloads.
00:03:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Downloaded Image Major Version
: 1
00:03:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Downloaded Image Minor Version :
0
00:03:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Downloaded Image Main Version :
0
00:03:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Downloaded Image Patch Version :
0
00:03:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Flash A Image Major Version : 9
00:03:07: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Flash A Image Minor Version : 1
00:03:07: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Flash A Image Main Version : 0
00:03:07: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART_RELEASE_HEADER_INFO: Flash A Image Patch Version : 222
00:03:07: %STKUNIT0-M:CP %JUMPSTART-2-JUMPSTART_DOWNLOAD_START: The FTOS image download has started.
Erasing IOM Primary Image, please wait
.............................................................................................
• If the versions match, the system downloads the configuration file or pre-configuration script.
00:03:27: %STKUNIT0-M:CP %JUMPSTART-5-CFG_APPLY: The downloaded config from dhcp server is being
applied
00:03:27: %STKUNIT0-M:CP %BMP-5-JUMPSTART: DHCP RELEASE sent on Fo 0/56.
00:03:27: %STKUNIT0-M:CP %SYS-5-CONFIG_LOAD: Loading configuration file
c If the configuration file or pre-configuration script is downloaded from the server, any saved
startup-configuration on the Flash is ignored. If no configuration file is downloaded from the
server, the startup-configuration file on the Flash is loaded as in Normal reload.
6. When the FTOS build image and the configuration file have been downloaded, the IP address is
released.
00:04:06: %STKUNIT0-M:CP %JUMPSTART-5-JUMPSTART: DHCP RELEASE sent on Fo 0/56.
00:04:06: %STKUNIT0-M:CP %IFMGR-5-ASTATE_DN: Changed interface Admin state to down: Fo 0/56
7. The system applies the configuration. The system is now up and running. It can be managed as usual.
BMP mode: Boot and Set-up Behavior
When a switch that is configured to reload in BMP mode boots up, one of the following scenarios may
occur:
• Reload without a DHCP Server Offer
• Reload with a DHCP Server Offer without an FTOS Image
• Reload with a DHCP Server Offer without a Configuration File
• Reload with a DHCP Server Offer without a DNS Server
• Reload with a Pre-configuration Script (BMP mode only)
• Using the Post-Configuration Script (BMP mode only)