Dell Force10 S4810P - Apply a Privilege Level to a Username; Apply a Privilege Level to a Terminal Line

56 | Management
www.dell.com | support.dell.com
end Exit from configuration mode
exit Exit from configuration mode
interface Select an interface to configure
line Configure a terminal line
linecard Set line card type
FTOS(conf)#interface ?
fastethernet Fast Ethernet interface
gigabitethernet Gigabit Ethernet interface
loopback Loopback interface
managementethernet Management Ethernet interface
null Null interface
port-channel Port-channel interface
range Configure interface range
sonet SONET interface
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN interface
FTOS(conf)#interface gigabitethernet 1/1
FTOS(conf-if-gi-1/1)#?
end Exit from configuration mode
exit Exit from interface configuration mode
FTOS(conf-if-gi-1/1)#exit
FTOS(conf)#line ?
aux Auxiliary line
console Primary terminal line
vty Virtual terminal
FTOS(conf)#line vty 0
FTOS(config-line-vty)#?
exit Exit from line configuration mode
FTOS(config-line-vty)#
Apply a Privilege Level to a Username
To set a privilege level for a user:
Apply a Privilege Level to a Terminal Line
To set a privilege level for a terminal line:
Task Command Syntax Command Mode
Configure a privilege level for a user.
username username privilege level
CONFIGURATION
Task Command Syntax Command Mode
Configure a privilege level for a terminal line.
privilege level level
LINE