EasyManua.ls Logo

Dell Force10 S4810P - Linecard Online Insertion and Removal

Dell Force10 S4810P
1144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
High Availability | 447
On the C-Series, when a secondary RPM with a logical SFM is inserted or removed, the system must add
or remove the backplane links to the switch fabric trunk. Any time such links are changed, traffic is
disrupted. Use the command
redundancy sfm standby to avoid any traffic disruption when the secondary
RPM is inserted. When this command is executed, the logical SFM on the standby RPM is immediately
taken offline, and the SFM state set as standby. Use the command
show sfm all to see SFM status
information.
FTOS#show rpm all
-- Route Processor Modules --
Slot Status NxtBoot Version
---------------------------------------------------------------------------
0 active online 7-5-1-71
1 not present
%RPM0-P:CP %POLLMGR-2-ALT_RPM_STATE: Alternate RPM is present
%RPM0-P:CP %IRC-6-IRC_COMMUP: Link to peer RPM is up
%RPM1-S:CP %RAM-5-RPM_STATE: RPM1 is in Standby State
FTOS#show rpm all
-- Route Processor Modules --
Slot Status NxtBoot Version
---------------------------------------------------------------------------
0 active online 7-5-1-71
1 standby online 7-5-1-71
Linecard Online Insertion and Removal
FTOS detects the line card type when you insert a line card into a online chassis. FTOS writes the line card
type to the running-config and maintains this information as a logical configuration if you remove the card
(or the card fails), as shown in the example below.
FTOS(conf)#do show linecard all
-- Line cards --
Slot Status NxtBoot ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 not present
[output omitted]
FTOS(conf)# %RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 0 present
FTOS(conf)# do show linecard all
-- Line cards --
Slot Status NxtBoot ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 online online E48VB E48VB 7-5-1-71 48
[output omitted]
FTOS(conf)#%RPM0-P:CP %CHMGR-2-CARD_DOWN: Line card 0 down - card removed
FTOS(conf)#do show linecard all
-- Line cards --
Slot Status NxtBoot ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 not present E48VB
[output omitted]

Table of Contents

Other manuals for Dell Force10 S4810P

Related product manuals