Dell Force10 S4810P - Multicast Features; Implementation Information; Enable IP Multicast

Multicast Features | 709
33
Multicast Features
Multicast Features are supported on platforms: e c s
This chapter contains the following sections:
• Enable IP Multicast on page 709
• Multicast with ECMP on page 710
• First Packet Forwarding for Lossless Multicast on page 711
• Multicast Policies on page 712
• Multicast Traceroute on page 719
FTOS supports the following multicast protocols:
• PIM Sparse-Mode (PIM-SM) on page 777
• Internet Group Management Protocol (IGMP) on page 459
• Multicast Source Discovery Protocol (MSDP) on page 665
Implementation Information
• Multicast is supported on secondary IP addresses on the platform.
Enable IP Multicast
Enable IP Multicast is supported on platforms c e s
Prior to enabling any multicast protocols, you must enable multicast routing.
Task Command Syntax Command Mode
Enable multicast routing.
ip multicast-routing
CONFIGURATION