Dell Force10 S4810P - Enable DHCP Server; Specify a Default Gateway

Dynamic Host Configuration Protocol (DHCP) | 383
Specify an Address Lease Time
Specify a Default Gateway
The IP address of the default router should be on the same subnet as the client.
Enable DHCP Server
This feature is available on c and s (S25/S50) platforms only.
The DHCP server is disabled by default.
In the illustration below, an IP phone is powered by PoE and has acquired an IP address from the Dell
Force10 system, which is advertising LLDP-MED. The leased IP address is displayed using
show ip dhcp
binding
, and confirmed with show lldp neighbors.
Task Command Syntax Command Mode
Specify an address lease time for the addresses in a pool. lease {days [hours] [minutes] |
infinite}
Default: 24 hours
DHCP <POOL>
Task Command Syntax Command Mode
Specify default gateway(s) for the clients on the subnet, in
order of preference.
default-router address
DHCP <POOL>
Step Task Command Syntax Command Mode
1 Enter the DHCP command-line context.
ip dhcp server
CONFIGURATION
2 Enable DHCP server.
no disable
Default: Disabled
DHCP
3 Display the current DHCP configuration.
show config
DHCP
7/1
Relay Agent
DNS Serve
r