Dell Force10 S4810P - Verifying DCB Configuration

Data Center Bridging (DCB) | 333
Verifying DCB Configuration
Use the show commands in Table 13-2 to display DCB configurations.
Figure 13-5. show dot1p-queue mapping Command Example
Figure 13-6. show dcb Command Example
Table 13-2. Displaying DCB Configurations
Command Output
show dot1p-queue mapping Displays the current 802.1p priority-queue mapping.
show dcb [stack-unit unit-number] Displays data center bridging status, number of PFC-enabled ports, and
number of PFC-enabled queues. On the master switch in a stack, you can
specify a stack-unit number. Range is : 0 to 5.
show qos dcb-input [pfc-profile] Displays the PFC configuration in a DCB input policy.
show qos dcb-output [ets-profile]
Displays the ETS configuration in a DCB output policy.
show qos priority-groups
Displays the ETS priority groups configured on the switch, including the
802.1p priority classes and ID of each group.
show interface port-type slot/port pfc
{summary | detail}
Displays the PFC configuration applied to ingress traffic on an interface,
including priorities and link delay.
To clear PFC TLV counters, use the clear pfc counters interface port-type
slot/port command.
show interface port-type slot/port pfc statistics Displays counters for the PFC frames received and transmitted (by dot1p
priority class) on an interface.
show interface port-type slot/port ets
{summary | detail}
Displays the ETS configuration applied to egress traffic on an interface,
including priority groups with priorities and bandwidth allocation.
To clear ETS TLV counters, enter the clear ets counters interface port-type
slot/port command.
show interface port-type slot/port DCBx detail Displays the DCBx configuration on an interface.
show stack-unit {0-11 | all} stack ports all pfc
details
Displays the PFC configuration applied to ingress traffic on stack-links,
including priorities and link delay.
show stack-unit {0-11 | all} stack ports all ets
details
Displays the ETS configuration applied to ingress traffic on stack-links,
including priorities and link delay.
FTOS(conf)# show dot1p-queue-mapping
Dot1p Priority: 0 1 2 3 4 5 6 7
Queue : 0 0 0 1 2 3 3 3
FTOS# show dcb
stack-unit 0 port-set 0
DCB Status : Enabled
PFC Port Count : 56 (current), 56 (configured)
PFC Queue Count : 2 (current), 2 (configured)