Dell Force10 S4810P - Assign a Static Ipv6 Route

IPv6 Routing | 553
One of the existing IPv6 addresses must be deleted before a new IPv6 address can be configured.
Assign a Static IPv6 Route
IPv6 Static Routes are supported on platforms c e s
Use the ipv6 route command to configure IPv6 static routes.
Command Syntax Command Mode Purpose
ipv6 address
ipv6 address/mask CONFIG-INTERFACE Enter the IPv6 Address for the device.
ipv6 address : x:x:x:x::x
mask : prefix length 0 to 128
IPv6 addresses are normally written as eight groups of four hexadecimal
digits, where each group is separated by a colon (:). Omitting zeros is accepted
as described in Addressing earlier in this chapter.