550 | IPv6 Routing
www.dell.com | support.dell.com
SSH over an IPv6 Transport
IPv6 SSH is supported on platforms c e s
FTOS supports both inbound and outbound SSH sessions using IPv6 addressing. Inbound SSH supports
accessing the system through the management interface as well as through a physical Layer 3 interface.
Refer to the
Security Commands chapter in the FTOS Command Line Interface Reference document for SSH
configuration details.
Configuration Task List for IPv6
This section contains information regarding the following:
• Change your CAM-Profile on an E-Series system (mandatory)
• Adjust your CAM-Profile on a C-Series or S-Series
• Assign an IPv6 Address to an Interface
• Assign a Static IPv6 Route
• Telnet with IPv6
• SNMP over IPv6
• Show IPv6 Information
• Clear IPv6 Routes
Change your CAM-Profile on an E-Series system
The cam-profile command is supported only on platform e
Change your CAM profile to the CAM ipv6-extacl before doing any further IPv6 configuration. Once the
CAM profile is changed, save the configuration and reboot your router.
Figure 25-4 displays the IPv6 CAM profile summary for a chassis that already has IPv6 CAM profile
configured. Figure 25-5 shows the full IPv6 CAM profiles. Refer to Chapter 11, Content Addressable
Memory (CAM), on page 273 for complete information regarding CAM configuration.
Command Syntax Command Mode Purpose
cam-profile ipv6-extacl
microcode ipv6-extacl chassis
| linecard slot
EXEC Privileged Enable the CAM profile with IPv6 extended ACLs
on the entire chassis or on a specific linecard
chassis changes the CAM profile for all linecards
in the chassis
linecard slot/port changes the CAM profile only for
the specified slot
To Next Page
Loading...
