Dell Force10 S4810P - Core 3 Rip Output; Rip Configuration on Core 3

Routing Information Protocol (RIP) | 855
RIP Configuration on Core 3
Figure 40-12. RIP Configuration on Core 3
Core 3 RIP Output
The screenshots in this section are:
• Figure 40-13: Using
show ip rip database command to display Core 3 RIP database
• Figure 40-14: Using
show ip route command to display Core 3 RIP setup
• Figure 40-15: Using
show ip protocols command to display Core 3 RIP activity
Figure 40-13. Using show ip rip database Command for Core 3 RIP Setup
Core3(conf-if-gi-3/21)#router rip
Core3(conf-router_rip)#version 2
Core3(conf-router_rip)#network 192.168.1.0
Core3(conf-router_rip)#network 192.168.2.0
Core3(conf-router_rip)#network 10.11.30.0
Core3(conf-router_rip)#network 10.11.20.0
Core3(conf-router_rip)#show config
!
router rip
network 10.0.0.0
network 192.168.1.0
network 192.168.2.0
version 2
Core3(conf-router_rip)#
Core3#show ip rip database
Total number of routes in RIP database: 7
10.11.10.0/24
[120/1] via 10.11.20.2, 00:00:13, GigabitEthernet 3/21
10.200.10.0/24
[120/1] via 10.11.20.2, 00:00:13, GigabitEthernet 3/21
10.300.10.0/24
[120/1] via 10.11.20.2, 00:00:13, GigabitEthernet 3/21
10.11.20.0/24 directly connected,GigabitEthernet 3/21
10.11.30.0/24 directly connected,GigabitEthernet 3/11
10.0.0.0/8 auto-summary
192.168.1.0/24 directly connected,GigabitEthernet 3/43
192.168.1.0/24 auto-summary
192.168.2.0/24 directly connected,GigabitEthernet 3/44
192.168.2.0/24 auto-summary
Core3#